With this shop-made bench dog I can put light right where I need it. The dog is just a square chunk of wood with two smaller pieces glued to the sides. The smaller pieces act as stops. I used my drill press to drill the hole to a diameter that matched the base of my desk lamp.
OnOurTable Walnut Knife Rack
Pull up a chair | Need to figure out the measurements on this and make a couple for the trailer. MyDesy Amoy inspiration
...simple wooden tape dispensers for washi masking tape...
re-fashioned Ikea kitchen cart. Using drawer slides, I refashioned one of the original grate-style shelves into a slide-out hammer rack. Immediately above that rack, again using drawer slides, I installed a layout board.
Hawk Vertical Clamping System If i ever need to clamp up large table tops